Printing first object transcoded with G-Code transcoder:
Simplify3D, 0.1mm layer
Acceleration 3000mm/s^2 and travel moves with >300mm/sec caused some missed steps. That’s why this little friend is looking a bit strange. Reduced the settings and next print came out a lot better:
UP G-Code-Transcoder full source code (and now also pre compiled binaries) available at github:
Mar 3 2016
UP! mini G-Code transcoder part3
Printing first object transcoded with G-Code transcoder:
Simplify3D, 0.1mm layer
Acceleration 3000mm/s^2 and travel moves with >300mm/sec caused some missed steps. That’s why this little friend is looking a bit strange. Reduced the settings and next print came out a lot better:
UP G-Code-Transcoder full source code (and now also pre compiled binaries) available at github:
https://github.com/MaikStohn/UP3D
By stohn • Uncategorized